8.5mm Thickness Lithium Polymer Cells / 3.7 V Li Poly Battery For Tracking Device 3000mAh 805068 manufacturer from China ShenzhenGreenEnergyTechCompany

8.5mm Thickness Lithium Polymer Cells / 3.7 V Li Poly Battery For Tracking Device 3000mAh

Place of Origin:

Zhejiang, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

Model No.: 805068

Tracking Device battery pack 3.7V 3000mAh with PCM, LI-PO cell 805068, also for tester, shaver

Tracking Device battery pack 3.7V 3000mAh with PCM, LI-PO cell 805068, also for tester, shaver and security alart devices

Advantages:

1, High energy density
2, High working voltage for single battery cells
3, Pollution-free
4, Long cycle life
5, No memory effect
6, Capacity, resistance, Voltage, platform time consistency is good
7, With short-circuit production function, safe and reliable
8, Factory price& High quality
9, Good consistency, low self discharge
10, Light weight, small size

Safety Precaution
1. Do not throw battery into water or make it wet;
2. Keep the battery away from heat source(like fire or heater);
3. Do not throw the battery into fire or heat the battery;
4. Forbid to hammer to trample the battery;
5. Forbid disassembling the battery in anyway

Specification:

Name	Deep cycle Lipo 3.7V 3000mah battery 805068
Model	805068
Size	Thickness × Width × Length (mm)
Size	8.5×51×70
Nominal voltage	3.7V
Nominal capacity	5000mAh
Max charge current	1C
Charging method	charge with constant current 1C to 4.2V, then charge with constant voltage 3.0V till charge current is less than 0.01C
Max discharge current	1C
Discharge cut-off voltage	3.0 V, the over-discharge detection voltage of PCM
Operating environment	Charging, 0°C ~ 65°C ; 65±20%RH
Operating environment	Discharging, -20°C~80°C ; 65±20%RH
Storage environment	-20°C~45°
	65±20%RH
	storage for a long time(>3 months) and the storage condition shall be:<35°C;65±20%RH;3.7~3.9V
CycleLife(80%Prime Capacity) :	>500times
warranty	Period of warranty: 12 months after sales
Identification	With protection board PCM for over charging, over discharging,short circut,over voltage.
	Using the charger designated by the manufacture.
	Don't throw the battery in fire or heat it.
	Don't short-circuit.
	Don't unpack the battery or change its structure.
Pack design	Battery pack should have sufficient strength and battery should be protected from mechanical shock
	No cell movement in the battery pack should be allowed.
	No Sharp edge components should be inside the pack containing the battery.
Charging	Charging current and charging voltage should be less than specified in the Product Specification.
	The charger shall be designed to comply with Product Specification.
	It is dangerous that charging with higher curren or voltage than Product Specification may cause damage to the cell electrical,mechanical safety performance.